The W5500 module is a module based on Ethernet WIZNET new type of chip W5500, module integrates the whole hardware TCP/IP protocol stack, no need code implements the TCP/IP protocol stack, support transmission rate of 10/100MBPS, support sleep mode and wake on LAN ,Within the integrated 32K TX/RX cache,support 8 independent ports run at the same time,Module supports 3.3V or 5V power supply, convenient for the user to use in the SCM system different, module and MCU system communication mode is SPI protocol,Support SPI clock frequencies up to 80M, provide STM32 and 51 SCM client, server, three modes of UDP routines.
In Stock
SPI to Ethernet Hardware TCP/IP W5500 Ethernet Network Module
Specifications:
- Chip type: W5500
- Supports both 3.3V & 5V
- Hardwired TCP/IP Protocols: TCP, UDP, ICMP, IPv4, ARP, IGMP, PPPoE
- 10BaseT/100BaseTX Ethernet PHY embedded
- Supports automatic response (full duplex/half duplex mode)
- Supports 8 independent sockets simultaneously
- Internal 32Kbytes Memory for Tx/Rx Buffers
₹488.52
CompareBestsellers
Compare
MCP2515 CAN Module TJA1050 Receiver SPI 51 Single Chip Program Routine Arduino
₹228.92(0 Reviews)
Features :
Input Supply voltage: 5V
Input Supply Current: 5 mA
Communication Rate: 1 Mbps
Support CAN V2.0B technical standard, communication rate 1Mb / S.
0 to 8 bytes long data field.
Use High-speed CAN transceiver TJA1050
SPI control for expanding Multi CAN bus interface
Use serial port could view the communication data
With the independent key, LED indicator, Power indicator
With power pin
Positioning screw hole center spacing 23 mm x 38 mm
The working current: typical 5mA, standby current 1 microamp. Except for the power indicator.
Compare
ST Link V2 Programmer For STM8 and STM32
₹297.36(0 Reviews)
QUICK OVERVIEW:
- PCB installed inside of aluminum alloy U disk shell, portable, safe and reliable!
- Interface definition directly marked on the shell, clear, convenient and practical!
- 5V, 3.3V offers at the same time, allowing you to program your target board with both 5V and 3.3V
- Shell characters using laser engraving, never fade off! Permanent clarity!
- 500MA internal resettable fuse, complete protection of your expensive computer motherboard!
- SWIM cable for connection to the application via a pin header or a 2.54 mm pitch connector
- SWIM programming speed rate: 9.7 Kbytes/s in low speed and 12.8 Kbytes/s in high speed
Compare
DVI TO HDMI Converter
₹188.80(0 Reviews)
Features:
Support 1080P, 3D for PS3,PS4,TV Box,Blu-ray,Projector,HDTV
Support connecting your HDMI-equipped source devices such as your Laptop/ Desktop, Blu-Ray, Xbox 360, PS3, Apple TV, DVD, and Set Top Box to your DVI-enabled HDTV, Displays or Projectors with your existing HDMI cable(not included)
Support connecting DVI source devices, like Laptop/ Desktop to AV receivers, HDTV and Displays with HDMI interface at high definition
Fully compatible with all HDTV formats. Supports resolution up to 1080p
Gold-plated connectors that resist corrosion while offering optimum signal transfer
High Speed HDMI Female to DVI 24+1 DVI-D Male Adapter Gold Plated Support 1080P for HDTV, Plasma, DVD and Projector
Compare
USB To TTL CP2102 Module / USB to Serial (6Pin)
₹149.86(0 Reviews)
Features:
- Included USB transceiver, without external circuit device
- With 3.3V and 5V dual power output
- With three LEDs: power indicator, data reception indicator, the data transmission indicator, working status
- Meets the USB2.0 specification requirements
- With self-recovery fuse. In the event of the accidental short circuit, it can effectively protect your computer USB port and Downloader
- Asynchronous serial data bus compatible with all handshake and modulation controller interface signals
- The supported data format is 8 data bits, 1 stop bit and parity bits
Compare
New ESC USB Linker Programmer For Simonk BLHeli Firmware SN/BL/16A/20A/30A/40A
₹528.64(0 Reviews)
Features:
Direct plug design, works with most USB port and USB extension cable
Low power consumption design
Onboard 2?3 Pin AVR ISP port
3pin servo connector can be used as servo or C2 connection
Supports SIMONK and BLHELI ESC, KKflashtool compatible
KKflashtool and RapidFlash compatible
Silabs CP2102 Driver chip! (Win, Mac, Linux)
Software upgradeable (via Arduino or BLHELISUIT)
Pre-load as BLHELISUIT 4w-if 14.1 firmware
Compare
ST-LINK/V2 in-circuit debugger/programmer for STM8 and STM32
₹831.90(0 Reviews)
Features:
- 5V power supplied by a USB connector
- USB 2.0 full speed compatible interface
- USB standard A to mini B cable
- 1.65V to 5.5V application voltage supported on SWIM interface
- SWIM low speed and high-speed modes supported
Compare
ENC28J60 Ethernet LAN Network SPI Module (10 pin) 11/46
₹342.20(0 Reviews)
Features:
3.3 V power supply pin.
SPI Interface with Clock Speeds Up to 20 MHz
The board 25MHZ crystal
Fully Compatible with 10/100/1000Base-T Networks
Integrated MAC and 10Base-T PHY
Supports One 10Base-T Port with Automatic Polarity Detection and Correction
Supports Full and Half-Duplex modes
Programmable Automatic Retransmit on Collision
SPI Interface with Clock Speeds Up to 20 MHz
For Arduino, SPI, AVR, PIC, LPC, STM32.
Reviews
There are no reviews yet.