Due to the COVID 19 epidemic, orders may be processed with a slight delay

Search

In Stock

Servo Motor ESC Tester

Specifications:

  1. Operating Voltage: DC 4.8-6V
  2. Offer 3 modes to check servos or ESC
  3. The Manual Mode allows you to turn the knob to different speeds and check the reaction time
  4. The Neutral mode makes the servo go back to the neutral point
  5. The Automatic ’’Window Wiper’’ Mode makes the servo swing like a window wiper in the largest angle possible
  6. Connect to up to 3 servos simultaneously.

106.20

Compare
SKU:cds-m-de-smet

A smart little servo tester can be used to test servo motor, ESC, and also to determine motor direction. Tests up to 3 servos at the same time.

The device also can be used as a signal generator for an electric speed controller (ESC), for testing your motor system without using a transmitter and receiver.

Digital Multi Servo Tester ESC RC Consistency CCPM Master Speed Control

It has three operation modes:

  1. Automatic mode:- Operates servos to their endpoint and back “window wiper” make the servo swing like window wipers in the biggest angle
  2. Manual mode:- Turn the knob with different speed, check the reaction time
  3. Neutral / Center mode: Centers servos to their neutral position Ideal for when setting servos up in a model

Reviews

There are no reviews yet.

Write a review

Your email address will not be published. Required fields are marked *

Bestsellers

Compare

16-Channel 12-bit PWM/Servo Driver I2C interface PCA9685 for Arduino Raspberry Pi

350.46
(0 Reviews)
Specifications:
  1. Adjustable frequency PWM up to about 1.6 KHz
  2. 12-bit resolution for each output – for servos, that means about 4us resolution at a 60Hz update rate
  3. Configurable push-pull or an open-drain output
  4. The output enable pin to quickly disable all the outputs
  5. Terminal block for power input
  6. Reverse polarity protection on the terminal block input
  7. Green power-good LED
Compare

Cellmeter 8 Multi-Functional Digital Power Servo Tester

789.42
(0 Reviews)
Specifications:
  1. Balance Discharge Current: 90mA × 8 Cell (Max@Cell Voltage 4.2v)
  2. Servo Test Frequency: 50Hz, 60Hz, 100Hz, 125Hz, 200Hz, 250Hz, 300Hz,
  3. Battery Voltage Test Precision: 0.001V
  4. Support Battery Type: Can test Li-Po, Li-ion, Li-Fe (2-8S), NiCd, NiMH(4-8S) battery
Compare

Servo Motor ESC Tester

106.20
(0 Reviews)
Specifications:
  1. Operating Voltage: DC 4.8-6V
  2. Offer 3 modes to check servos or ESC
  3. The Manual Mode allows you to turn the knob to different speeds and check the reaction time
  4. The Neutral mode makes the servo go back to the neutral point
  5. The Automatic ’’Window Wiper’’ Mode makes the servo swing like a window wiper in the largest angle possible
  6. Connect to up to 3 servos simultaneously.
Compare

Servo/PWM Driver Adafruit 16-Channel 12-bit I2C interface PCA9685

289.10
(0 Reviews)
Specifications:
  • 5V compliant, and still talks to a 3.3V microcontroller
  • 6 “address select” pins for configuring up to 62 ICs on a single I2C bus
  • PWM frequency adjustable up to approximately 1.6kHz
  • 12-bit frequency resolution (equates to about 4µs resolution at 60Hz refresh rate)
  • Configurable as push-pull or open-drain output
  • Output enable pin available for outside-the-microcontroller “shut it down!” control.

Back to Top
Product has been added to your cart