Due to the COVID 19 epidemic, orders may be processed with a slight delay

Search

In Stock

Cellmeter 8 Multi-Functional Digital Power Servo Tester

Specifications:

  1. Balance Discharge Current: 90mA × 8 Cell (Max@Cell Voltage 4.2v)
  2. Servo Test Frequency: 50Hz, 60Hz, 100Hz, 125Hz, 200Hz, 250Hz, 300Hz,
  3. Battery Voltage Test Precision: 0.001V
  4. Support Battery Type: Can test Li-Po, Li-ion, Li-Fe (2-8S), NiCd, NiMH(4-8S) battery

789.42

Compare
SKU:cds-m-de-c8-dpst

Servo Tester is really useful for the drone builders, you can use it to spin up your motors to check spin direction without having to use an FC or receiver. For those into planes, you can use it to check servo throws and set the neutral point.

The Cellmeter 8 Multi-Functional Digital Power servo Tester is an essential piece of equipment any hobbyist using LiPo batteries should own. The Cellmeter 8 will help you to quickly diagnose the health of your pack with an easy-to-read LCD screen, this unit works with any LiPo pack from 2s~8s.

This Multifunctional fully Automatic indispensable tool gives you the following information in a logical and easy to follow pattern with a simple push of a button. Can be used to check the battery voltage of Lithium batteries including Li-PO, LiFe, Li-Ion, as well as NiMH and NiCd batteries.

Measure the voltage of both individual cells and full battery voltage, and can also indicate the highest voltage cell, lowest voltage cell, and difference that is various Display Mode: Battery Cell Voltage, Total Voltage, Lowest Cell Voltage, Highest Cell Voltage, Voltage Gap Between Highest and Lowest Cell and Remaining Battery Capacity in Percent(%). 

Package includes :

1 x  Cellmeter 8 Multi-Functional Digital Power servo Tester

Reviews

There are no reviews yet.

Write a review

Your email address will not be published. Required fields are marked *

Bestsellers

Compare

16-Channel 12-bit PWM/Servo Driver I2C interface PCA9685 for Arduino Raspberry Pi

350.46
(0 Reviews)
Specifications:
  1. Adjustable frequency PWM up to about 1.6 KHz
  2. 12-bit resolution for each output – for servos, that means about 4us resolution at a 60Hz update rate
  3. Configurable push-pull or an open-drain output
  4. The output enable pin to quickly disable all the outputs
  5. Terminal block for power input
  6. Reverse polarity protection on the terminal block input
  7. Green power-good LED
Compare

Cellmeter 8 Multi-Functional Digital Power Servo Tester

789.42
(0 Reviews)
Specifications:
  1. Balance Discharge Current: 90mA × 8 Cell (Max@Cell Voltage 4.2v)
  2. Servo Test Frequency: 50Hz, 60Hz, 100Hz, 125Hz, 200Hz, 250Hz, 300Hz,
  3. Battery Voltage Test Precision: 0.001V
  4. Support Battery Type: Can test Li-Po, Li-ion, Li-Fe (2-8S), NiCd, NiMH(4-8S) battery
Compare

Servo Motor ESC Tester

106.20
(0 Reviews)
Specifications:
  1. Operating Voltage: DC 4.8-6V
  2. Offer 3 modes to check servos or ESC
  3. The Manual Mode allows you to turn the knob to different speeds and check the reaction time
  4. The Neutral mode makes the servo go back to the neutral point
  5. The Automatic ’’Window Wiper’’ Mode makes the servo swing like a window wiper in the largest angle possible
  6. Connect to up to 3 servos simultaneously.
Compare

Servo/PWM Driver Adafruit 16-Channel 12-bit I2C interface PCA9685

289.10
(0 Reviews)
Specifications:
  • 5V compliant, and still talks to a 3.3V microcontroller
  • 6 “address select” pins for configuring up to 62 ICs on a single I2C bus
  • PWM frequency adjustable up to approximately 1.6kHz
  • 12-bit frequency resolution (equates to about 4µs resolution at 60Hz refresh rate)
  • Configurable as push-pull or open-drain output
  • Output enable pin available for outside-the-microcontroller “shut it down!” control.

Back to Top
Product has been added to your cart