Showing 49–60 of 100 results
Compare
PAM 8610 Digital Stereo Class-D Amplifier Board 2x15W Output
₹171.10(0 Reviews)
Features:
- Dual-Channel Stereo Output
- Run-on 7V to 15V power Supply
- 32 Steps DC volume control has a +32dB to -75dB range.
- 40 pin QFN 6 x 6 mm package.
- Much higher efficiency in terms of cost and performance than competitors’ ICs
Compare
PAM8403 mini digital Power amplifier 3W Dual Track Red
₹92.04(0 Reviews)
Features :
- A d-type amplifier without a filter, low quiescent current, and low EMI.
- When connects with a 4-ohm load and 5V power supply, the output power can be up to 3W.
- Low THD, low noise.
- Short circuit protection; thermal protection.
- Input Voltage : 2.5-5.5 V(USB power supply).
- Output Impedance : 4 ohm.
- Efficiency : 90%.
- Frequency Response : 150 Hz – 20 KHz.
- Input Impedance : 2 Kohm.
- Dimensions : 15 x 20 mm.
Compare
PCF8574 IO Expansion Board
₹99.12(0 Reviews)
Specifications:
8-Bit I/O Expander For I2C-Bus
PCF8574 On Board
Compare
PCF8591 Module Analog to Digital / Digital-Analog Converter Module with F-F Jumper Wire
₹207.68(0 Reviews)
Specification:
1. Module PCB size: 3.6cm * 2.3cm
2. PCF8591 operating voltage range of 2.5V to 6V
3. 4 analog inputs programmable as single-ended or differential inputs
4. VCC power supply interface external 3.3v-5v
5. 8-bit successive approximation A / D converter through an analog output DAC gain
Compare
PIC 18F4550 IC
₹330.40(0 Reviews)
Features:
PIC18F4550 – Simplified Features
CPU
8-bit
Total Number of Pins
40
Operating Voltage
+4.0 to +5.5 V (+5.5V being absolute maximum)
Number of programmable I/O pins
35
Communication Interface
USB Serial Interface (23,24 PINS) [Can be used for programming this controller]
Master/Slave SPI Serial Interface(7,26,33, 34 PINS) [Can be used for programming this controller]
Programmable Serial UART(25,26 PINS) [Can be used for programming this controller]
Two-wire Serial Interface(33, 34 PINS)[Can be used to connect peripheral devices like sensors and LCDs]
ADC Module
13channels, 10-bit resolution ADC
Timer Module
One 8-bit counter, Three 16-bit counter
Analog Comparators
2
PWM channels
4
External Oscillator
Up to 48MHz
Internal Oscillator
32KHz-8MHz Calibrated Internal Oscillator
Program Memory Type
Flash
Program Memory
32Kbytes[10000 write/erase cycles]
CPU Speed
12 MIPS
RAM Bytes
2KBytes
EEPROM
256Bytes
Watchdog Timer
Programmable Watchdog Timer with Separate On-chip Oscillator
Power Save Modes
Available
Operating Temperature
-40°C to +85°C(+85 being absolute maximum, -40 being absolute minimum)
Compare
PIC Programmer Development Board
₹999.46(0 Reviews)
FEATURES :
1. PIC Development Board for Microchip any 40 PIN PIC Series like. 16FXXX, 18FXXX (EX. 16F877A – 40 PIN).
2. ICSP Socket for Programming through PICKIT2 or PICKIT3.
3. On board Regulated 5v ,12v Supply.
4. Easy to test with Burg Connectors wires.
5. An RS232 Serial Port.
6. 7 Segment Multiplexed Display.
7. DC Power Supply Connector(12v Ac or Dc).
8. READY INTERFACE For LCD display 2linex16Character.
9. 24Cxx (I2C) (EEPROM).
10. RTC (DS1307).
11. 4 LED array.
12. Matrix Key Pad.
13. 4 Interrupt Switches.
14. ADC Interface Support.
15. ULN2008 Support For Interfacing Stepper Motors. Package Content : PIC Development Board for Microchip any 40 PIN PIC Series like. 16FXXX, 18FXXX (EX. 16F877A – 40 PIN).
Compare
PICKIT 3.5 Debugger / Programmer
₹1,475.00(0 Reviews)
Specification :
- USB (Full speed 12 Mbits / s interface to host PC)
- Real-time execution
- MPLAB IDE compatible (free download from Microchip)
- built-in over-voltage / short circuit monitor
- Firmware upgradeable from PC / web download
- totally enclosed
- Diagnostic LEDs (power, busy, error)
- read/write program and data memory from a microcontroller
- erase program memory with Verification
- Freeze peripherals at a breakpoint
- program up to 512K byte flash with the Programmer to Go
- ICSP cable included
Compare
PICKIT 3.5 Debugger / Programmer
₹1,475.00(0 Reviews)
Specification :
USB (Full speed 12 Mbits / s interface to host PC)
Real-time execution
MPLAB IDE compatible (free download from Microchip)
built-in over-voltage / short circuit monitor
Firmware upgradeable from PC / web download
totally enclosed
Diagnostic LEDs (power, busy, error)
read/write program and data memory from a microcontroller
erase program memory with Verification
Freeze peripherals at a breakpoint
program up to 512K byte flash with the Programmer to Go
ICSP cable included
Compare
PICKIT3 USB PIC PROGRAMMER/DEBUGGER
₹1,203.60(0 Reviews)
Specifications:
- Type: Debugger/Programmer
- Tool/Board Application: Debugging/Programming
- MCU Supported Families: Flash-based PIC MCUs
- Core Architecture: PIC, dsPIC
- IC Product Type: In-Circuit Debugger
